Online Stock Only.
For "click and collect" orders at Lynbrook store the shipping fee will still apply on collection for items not stocked at the Lynbrook store.
120W RMS Two Channel Power Amplifier with Dante
Features
- Stereo into 4-8 Ohm loads
- Bridgeable for 70V or 1 00V (Direct Drive)
- Slot card with integrated Dante receiver
- Power down after -15 minutes of no signal and comply with Energy Star Power consumption limits of < 0.5W in standby
- Yellow LED (Front Panel) to indicated Standby mode is active
- Terminal Block analog audio inputs on 2 CH amp
- 2 x amplifier outputs, bridgeable to 1 channel
- Volume, Auto on/off signal sensing
- Natural cooling without Fan
- TRIGGER could be external remoting ON/OFF
- Short circuit protection
- Overheating protection
Specifications
Dante Audio Interface
- 2x2 audio channels
- I2S digital audio format
- 16, 24 or 32-bit audio samples (per device or per channel)
- 44.1 KHz, 48KHz, 88.2KHz and 96KHz sample rate
Network Interface
- Standard 100Mbps Ethernet
- RMII Ethernet interface with MDIO
- Hardware time-stamping, supporting sample-accurate playback
- Transmit flows: 2 (unicast or multicast)
- Receive flows: 2 (unicast or multicast)
- Latency from 2ms
Amplifier/ Rated Power
- 4ohm Stereo Mode = 120W (22 V) RMS output (steady state). per channel @ < 1 % THD+N
- Bohm Stereo Mode = 120W (31 V) RMS output (steady state), per channel @ < 1 % THD+N
- 70V Bridge Mode= 240 W output (steady state), per channel@ < 1 % THD+N
- 100V Bridge Mode= 240 W output (steady state), per channel@< 1 % THD+N
- 1/8 Rated Power Run Time: continuous operation
- Frequency Response: 20Hz-20kHz +0/-2dB @ 4ohm load
- Signal to Noise: >90dB A WTD
- Dimension: 214mm(W) x 249.Bmm(D) x 44mm(H)
